I have four new Dell Laptops, two are Latitude D830's and two are Precision M6300's that all have this Dell wireless 1395 WLAN mini card. In the office we have wifi setup that all the rest of ...
A friend has an HP Pavilion dv2035us. After connecting to my wireless for a few seconds we get that error message "Windows was unable to find a certificate to log you to the network" and it d...
Heeeeeeelp :)
I have two Linksys gadgets...
One is a WRT54GC router - fine and small piece of hardware
Another one is an Linksys WAP54G Access Point.
I would like to connect these two ...
I have the following network setup:
Linksys 8 port router (RV082) at the center of my network. DHCP server turned on.
Two linksys wireless g routers (WRT54G and WRT54GS respectively) conne...
I have 3 computers in the household, 1 desktop and 2 Dell PCs
We have a wireless router (Belkin Wireless G Plus MIMO F5D9630-4)
The desktop is hardwired to the router and I can browse to...
How can I get a Linksys wireless router see an existing network?
I am doing a workgroup setup for a very small office (must be a workgroup cannot be a domain). They have a DSL business rout...
Hello guyz,
I am new here and I am happy that I found this great forum after some google.
Well I use desktop, my OS is WinXP Pro. Before I was using Cable Internet and it used to work fi...
I have read all of the posts regarding similar issues with upgrading from LWAPP to Autonomous Mode. Here is my case:
I have 2x Aironet 1131AG Wireless Access Points.
One is brand new and...
We have an AT&T-supplied 2Wire modem/router as our primary router. It cannot be moved since it is located where the internet connection comes into our home and does not provide sufficient sign...
Using the Windows Wireless Client to manage WiFi connections and wanted to know if there was any way to determine the mac address of the currently associated access point? This is possible usi...
I have been fighting a wireless networking problem that is starting to get the better of me. I am in a single floor medical building with 4 pods of exam rooms. In the center of each pod is a...
I have bellsouth DSL connected to a Westell 6100 modem. This is connected to linksys router. Router ethernet port to main pc ethernet port. Laptop has linksys USB WAP, works fine. Main PC->LAN...
We have a small wired network based around a D-Link Modem/Router. In another building approx 20m away there is a Belkin Wireless Pre N Router set up as an access point wired back to the D-Link...
Difference between WEP and WPA ?
If WPA is enabled on wireless device, Then only same key to give to access.
But in WEP is different. You need to gerenate, how it work?
hi, i have a dlink DWL-2100AP , suddenly the power led is blinking all the time and i can't locate its ip address. i tried to reset it but no luck still the same.
The power is unplugged then ...
Is it possible to change MAC address of access point (I have D Link DWL-900AP+, but I am also interested in general)? When I enter setup there is Advanced tab where there are some options tha...
Hello experts:
I just set up a WAP (Netgear WG102) to act as a repeater. There is wireless access to part of the area but two of the furthest rooms get very low quality signal and it will ...
We purchased a new Cisco Aironet 1231G. I have worked with the 1200 series before but never this model. When I log into the console, I can get to enable mode but the unit does not take a "co...
I recently purchased this aironet 1200 series AP and was upgrading the firmware. It seemed to complete successfully but I am no longer able to access it. Is there a way to reset this to factor...
Hello:
I just purchased a Linksys WAP200 access point and need to configure it to be in repeater mode. My LAN network default gateway is 10.10.10.1. I currently have a LInksys Wireless Router...
Hi Guys,
I need to know if you can convert an AIR-LAP1231G Cisco Lightweight Access Point into autonomous mode. The only articles i can find are to ugrade an autonomous access point to a ligh...
Hi guys, me again.
I need to know what will be the simplest way to set up a Netgear Wireless router DG834GT with a Netgear WG102 Prosafe 802.11g Wireless Access Point. But there is a catch....
Experts, I have a dilemma. Our CEO has a huge house in Malibu, CA. The house looks like a rectangle. The Wireless Router is on one side of the house, and a workstation connected via Network Ca...
I installed a Cisco ASA 5505 on my network, the later installed and configured a Cisco Aironet 1130AG AP for wireless access to the network, works great. Now my company would like to add gues...
I hope this is in the correct area, if not please feel free to move and please excuse my error.
I have a wireless network at a public library that is essentially it's own network (ie, subne...
